Introduction: W153 LED LED controller is controlled through infrared remote, it able to drive the LED RGB light strip (5050 LED RGB up to 3M) or direct drive the W115 LED RGB Booster (need only if the load of the LED RGB light strip exceeds the rated output of the controller or decoder you will use).............. Technical Specifications: Remote Control Power Supply: Transmit distance: 1 x CR2025 (3V). Up to 3M at 30° angle. RGB Controller Power Supply: 12VDC. Controller switching (sinking) capacitive: 1A/Channel (only for common anode RGB light strip). Physical Size (remote): 85mm x 40mm x 7mmD............... Description: Remote control (battery operated) 1. ON/OFF button. 2. Mode button. a) Auto change. b) 3 color jumpy. c) 3 color fade. 3. black colour up/down button: speed adjust for mode button(8 level). 4. Delay button: speed adjust (speed adjust for programming colour). 5. Clear delay: restore to default speed (speed adjust for programming colour). 6. Red colour programming button. Hold up to increase or down to decrease (20 level). 7. Green colour programming button. Hold up to increase or down to decrease (20 level). 8. Blue colour programming button. Hold up to increase or down to decrease (20 level). 9. Save: to store the programming colour. Press button once after step 6,7,8. 10. Colour button: Preset 7 colour for programming. 11. Clear button: to delet the programming colour. W153 features built in non-volatile EEPROM, which store the last mode and speed level even after power off. Note: Insert the battery in the battery holder respecting the polarity. Always replace a drained battery by a battery with the same specifications.............. Email us at sales@wintech.com.sg or visit us at http://www.wintech.com.sg ................ Disclaimer: All Win Tech kits have been well tested. Win Tech is not responsible for any damages caused by the usage of our kits.............. The information in this manual is subject to change without prior notice.